Ameda Platinum
Breast Pump Quick Start

• If kit is sterile, use preassembled kit immediately.
• If not sterile, clean, sanitize and assemble the kit (follow cleaning instructions on the back of this card).

• First connect one end of the power adapter to the back of the pump, then the other end to an electrical outlet.

• Insert tubing adapter firmly into port under gray flap on front of pump.
• If not double pumping, REMOVE ONE TUBE and insert the attached plug into the unused port of the adapter.

• Center flange on breast and press firmly to create a tight seal. (see back of card for proper fit).

• Push power button.
• Pump starts in Stimulation Mode.

Adjust Stimulation Suction

• Adjust the Stimulation Suction setting gradually to your preferred comfort level (maximum 6)

Change Mode

• Once your milk starts to flow using the STIMULATION MODE, press the Mode (M) button to switch into Expression Mode.

Adjust Expression Suction Level

• Adjust the Expression Suction setting gradually to your preferred comfort level (maximum 12).

Adjust Speed

• Adjust the speed in Expression Mode to your preferred comfort level (maximum 6).
• Once your milk stops flowing freely while in Expression Mode, press the Mode button to go back to Stimulation Mode to induce a second let-down if desired.

End Pumping Session

• When finished pumping, press power button to turn off.